[China Glass Net] Air compressor is a common small equipment used as a glass consumable tool, which is no stranger to art glass practitioners. In the actual use process, Longxiang Art Glass found that many customers are not too concerned about the maintenance of air compressors. Many air compressors are damaged due to improper maintenance or excessive use. For your air compressor to work long life. The following Longxiang art glass combines years of experience to talk about the common sense of using maintenance for your reference.
Longxiang Art Glass Project
First, the damage caused by impurities.
Air compressors, as the name implies, are machines that compress air. The source of air is the air around the equipment. If the air compressor is placed in a place where dust and dust gather for a long time, the service life will be greatly reduced. The reason is very simple. Particles or dust will not only scratch the cylinder as the air enters the cylinder, but also severely wear the piston and other components. Causes the equipment to be used without life. Therefore, when using the air compressor, we should place the air compressor in a place with a relatively clean air. Keep it ventilated and dry. It can be solved by the extension of the available air belt.
Second, oil and gas emissions.
There is moisture in normal air. When the air compressor is working, not only the air is compressed and output, but also a considerable part of the water is pressed into the machine. At the same time, the lubricating oil in the machine evaporates and then condenses, and it is easy to form an oil-water mixture. This oil-water mixture causes serious quality problems such as mottling and varnishing when painting, and it is a common phenomenon to block the muzzle during sand blasting. The more extreme example seen by Longxiang Art Glass, an air compressor has half a tank of water. Therefore, often putting this mixture of oil and water is one of the common tasks of maintaining air compressors. If there are conditions, install a water filter.
Third, place the flat
Some air compressors fall off due to improper maintenance of the wheels during use. Some users use a wooden block to support a corner. The air compressor shakes left and right while working. And many users are not too concerned about this kind of shaking. The actual situation is. When the air compressor is working, the four corners must be stable and high. Otherwise, unnecessary wear will be caused to the air compressor cylinder and the piston to reduce the life. It is often the case that if an air compressor wheel is removed, it is not far from being broken. So if the air compressor fulcrum falls off, be sure to find a way to weld one. Don't make a temporary padding.
Fourth, the replacement and replacement of lubricating oil
Many customers have not replaced the lubricating oil until the air compressor is used badly. It is better to say that the air compressor is worn out rather than being used up. Most of the cylinder equipment needs to have lubricants to participate in the work. Just like a car, you will need to check regularly to add or replace lubricants. This is also the maintenance work that is often done. The oil level should be seen frequently, and the oil should be replaced regularly. If you find that the lubricating oil is quickly lost, you must stop the air compressor and check it for repair.
Satin Stretch Fabric,Stain Resistant Fabric,Polyester Satin Fabric,100% Polyester Satin Fabric
Shaoxing Cornfield Textile Trading Co,.Ltd , https://www.cornfieldtextile.com